Technical perspective
A spice powder can look dry, smell normal and still need a carefully designed microbiological control programme. For quality teams, the useful question is not simply whether a finished-product sample passed. It is whether the business can show how contamination is prevented, detected and investigated across the process.
Article section
1. Separate survival from growth
Codex’s Code of Hygienic Practice for Low-Moisture Foods explains that Salmonella may remain viable for long periods even when low water activity prevents multiplication. It also highlights increased heat tolerance at reduced water activity. Dryness is therefore not a microbial kill step, and a treatment validated for one product should not automatically be transferred to a different formulation. Particular attention is needed where food is exposed after a pathogen-reduction step or ingredients are added afterwards. [1]
Begin with a process map that identifies incoming materials, any microbial-reduction treatment, blending, rework and exposed packing. Mark the point beyond which contamination would no longer encounter a validated control. This makes the safety discussion specific to the actual line rather than to a generic “spices” category.
Article section
2. Make supplier and dry-area controls visible
FSSAI’s spice-processing guidance covers raw-material checks, hygienic equipment, maintenance, storage and staff practices. It advises inspection of incoming spices and appropriate laboratory testing when necessary. It also emphasises keeping spice-handling areas dry and allowing equipment to dry thoroughly after necessary wet cleaning. These are practical guidance points; the document explicitly says applicable legislation prevails. [2]
A useful receiving record should connect the supplier, ingredient, lot and acceptance decision. A certificate without a clear lot connection is difficult to use during an investigation. On the floor, review how raw materials, tools, people and dust move towards exposed finished product. Include maintenance contractors in the review: a repair can change a previously controlled traffic route or introduce equipment that has not passed the normal hygiene checks.
Article section
3. Design monitoring around a decision
Codex supports environmental monitoring to verify hygiene controls and find potential contamination sites in low-moisture operations. Salmonella is the key target where it is the relevant hazard. Enterobacteriaceae can provide supplementary hygiene information, but indicator testing alone cannot establish Salmonella absence. [1]
For each sampling location, write down the question being asked. Is the programme checking an exposed-product area, investigating a recurring finding, or evaluating a change after maintenance? Agree the method, sample handling and interpretation with a competent laboratory before collection. Do not borrow a fixed swab count or frequency without considering the plant’s hazards and layout.
Article section
4. Decide the response before a result arrives
The US FDA’s January 2025 low-moisture ready-to-eat food guidance remains labelled draft, non-binding and not for implementation on its official page. It is an international technical reference, not an Indian legal requirement. Its discussion usefully links sanitation, environmental monitoring, root-cause investigation and identification of potentially affected food. It also warns about relying solely on product testing to demonstrate that contamination has been eliminated. [3]
As a practical exercise, work through a hypothetical positive finding. Who can stop dispatch? Who identifies potentially affected lots? What evidence will support the investigation and the eventual disposition decision? Separate immediate containment from the work needed to correct the underlying cause. A negative follow-up sample should not, by itself, close an unresolved investigation.
Article section
5. Give auditors a clear evidence trail
The following is a suggested review sheet, not a prescribed regulatory form:
- Hazard and location: what could contaminate which product?
- Control owner: who checks the measure and escalates a deviation?
- Evidence: which supplier record, process record or laboratory result supports the decision?
- Action: what happened to the material, equipment and affected product?
- Closure: who accepted the evidence that the correction worked?
Use one recent lot and one maintenance event for a short team exercise. Ask operators to trace the records without coaching. Any missing link is a useful training topic. The aim is an understandable system that works during production and an investigation, not just a folder prepared for an audit.
Scope note: This article offers technical guidance, not a product-specific legal opinion. Select current applicable Indian requirements and any destination-market rules for the actual product. Any proposed laboratory work must be checked against the provider’s current matrix, method and accreditation scope. No specific Chem-Tech testing scope or accreditation claim is made here.
Article section
Sources
[1] Codex, Code of Hygienic Practice for Low-Moisture Foods, CXC 75-2015, adopted 2015, revised 2016, amended 2018. Sections on low-moisture hazards and environmental monitoring. Official indexed text checked 16 October 2026; direct download was intermittently unavailable.
https://www.fao.org/fao-who-codexalimentarius/sh-proxy/fr/?lnk=1&url=https%3A%2F%2Fworkspace.fao.org%2Fsites%2Fcodex%2FStandards%2FCXC+75-2015%2FCXC_075e.pdf
[2] FSSAI, Food Safety Management System Guidance Document: Spice Processing, first edition October 2018. Official PDF read 16 October 2026. Background guidance, not a newly issued 2026 rule.
https://www.fssai.gov.in/upload/uploadfiles/files/Guidance_Document_Spices_23_10_2018.pdf
[3] US FDA, Draft Guidance for Industry: Establishing Sanitation Programs for Low-Moisture Ready-to-Eat Human Foods and Taking Corrective Actions Following a Pathogen Contamination Event, January 2025. Official page checked 16 October 2026; still marked Draft / Not for implementation / non-binding recommendations.
https://www.fda.gov/regulatory-information/search-fda-guidance-documents/draft-guidance-industry-establishing-sanitation-programs-low-moisture-ready-eat-human-foods-and
Apply this guidance



